AC180V-260V Input DC220V Output 8A PWM DC Motor Speed Controller Driver HX-SXPWM For Sale

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

AC180V-260V Input DC220V Output 8A PWM DC Motor Speed Controller Driver HX-SXPWM:
$48.95

• The input power supply (VAC): AC180-260V 50 / 60Hz (for global voltage)
• The output armature voltage range (VDC): DC220V
• The output armature current range (A): 8A (0.1A-10A can be arbitrarily set) . If the current is too big need to increase the heat
• The output excitation voltage range (VDC): 100/200 (default full-bridge rectifier, which is 0.9 times the input voltage)
• The output excitation current range (A): 1A
• The working frequency: 16 KHz
• Given signal mode (V / mA): default potentiometer, 0-5V, 0-10V, 4-20mA, PWM, touchtone
• Enable control mode (EN): switch
• Soft start (acceleration time adjustment range) (S): 0-10S (default 2 seconds)
• Soft stop (deceleration time adjustment range) (S): 0-10S (default 2 seconds)
• Double loop PI regulation (voltage and current) control is more reliable
• IR torque compensation range: 0-100% (default 0)
• Overcurrent range: 0 setpoint (default 8A)
• Overcurrent mode: stop output and indication (display code E1)
• Short-circuit protection: stop output and indication (display code E0)
• Overheat protection: power tube temperature exceeds 100 ° off the output and the indication (display code E2)
• Built-in digital display module can display real-time operating voltage with current
• Dimensions: Length 140mm × 98mm × height 38mm width
• Connection: terminal type pulse technology to speed more stable, low speed forceful
• With a short circuit, overcurrent, overtemperature protection cutoff device to make more reliable performance
• With the elimination of soft starter motor starting current is too large
• High and low voltage signal is completely isolated, the use of governor closed the input power,
• Touched by hand within a minute ban high-voltage terminal,
• There are high-voltage capacitors,
• To prevent electric shock!!!
• For the two lines of DC permanent magnet motor,
• Two lead wires connected directly to the armature M + with M-.
• Prohibit access exciting!

1. *5V level without resistors in series with PWM input port,
2. *10V PWM level from 0-10V input port or serial port 10K resistor in the PWM input,
3. *12V level 3.9K resistor string from 0-10V input port or serial port 13.7K PWM input resistors,
4. *24V level string 27K resistor from 0-10V input port or serial port 16.8K resistor PWM input

AC180V-260V Input DC220V Output 8A PWM DC Motor Speed Controller Driver HX-SXPWM

$48.95