Originally Posted By: paul
well , I couldnt get the force to lower , so
I suppose that the design needs to change.
the lenght and time of the turn never affected the total force applied.

Really? If the turnaround was longer, the radius would be larger, causing a reduced centrifugal force.

Quote:

the two turns cancel each other out.
-8000N
+8000N

If they're being used simultaneously.


Quote:

so its now a matter of timming these two masses.

Not sure where the 2nd acccelerator would go ?? But I don't think it's possible to keep them synchronized -

Suppose both masses enter and exit their opposite turnarounds at the same time and with the same speed.

The mass that went through the 1st turn floats to the 2nd turn. But the mass that's gone through the 2nd turn is then accelerated and reaches its 1st turn sooner. They're now out of sync.