Star Trek TOS, Dr. McCoys MoPop-Museum-Copy, Medical Scanner Parts Kit for Sale

Star Trek TOS, Dr. McCoys MoPop-Museum-Copy, Medical Scanner Parts Kit For Sale

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Star Trek TOS, Dr. McCoys MoPop-Museum-Copy, Medical Scanner Parts Kit:
$99.00

I ship what you see in the photos (GREEN BACKGROUND PART):

Black Body hard anodized. Switch Hole .259 inches (for 7mm push button), 3 holes .059 inches opposite for air release (breaks vacuum and allows cap to seat and remove) OR .059 holes allow for adding sound.

Clear interior body cavity is 1.188 inches diameter x .98 high with the cap installed. Spacious for a sound board that YOU provide.
Body Cap; machined aluminum with 3/8 motor hole and O-Ring and O-ring groove for securing and removing top FROM BLACK BODY and a Groove for 1 inch outer fixed acrylic tube to seat into. The body cap may be very-very-snug HOWEVER adding some Vaseline or a drop of oil to the O-Ring will make the parts more easily assemble and disassemble.
Bottom Plate; laser and machine engraved, suggest red-dots enamel, red-triangle enamel, white bars enamel, OR flip over for orthodox TOS buffs who prefer a plain bottom.
Outer Acrylic 1" diameter and machined to correct height. Acrylic cap for 1" diameter tube has been changed to a thinner 1/16" thickness to more closely resemble the Set-Used MoPop original Prop.
Inner acrylic 3/4 inch diameter and machined to correct height.
BUILDER TIP: Paint the outside (or inside if you prefer) of the 3/4 inch spinner tube Tamiya Silver Leaf Color before the assembly to inner aluminum spinner cap and motor.
Custom Machined aluminum 3/4 inch inner-spinner-cap with motor boss and set screw included ! (300 rpm)
Three Red pinstripes for 3/4 acrylic.
Three Round 3/4" hologram stickers AND Three Round 1" silver stickers for 3/4 diameter inner-acrylic-spinner.
Black top push button momentary switch (suggest nut & washer be painted black by the builder, (I discard the washer)
Motor is a DC 3.5 to 4.5 volts at the correct 300 RPM for Star Trek with brass gearbox and a flat spot on the shaft and, the motor comes with pre-soldered leads. The motor does project down into the clear inner cavity of the Black Anodized Body by 3/16 inches (nominal) at the 3/8 inches diameter.
LR44 x 3 holder is the white one for a 4.5V set up.