GBS-8200 3D Printed Enclosure - Commodore Amiga Style for Sale

GBS-8200 3D Printed Enclosure - Commodore Amiga Style For Sale

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

GBS-8200 3D Printed Enclosure - Commodore Amiga Style:
$55.99

GBS-8200 3D Printed Enclosure - Commodore Amiga StyleEnclosure Only - electronics are not included
This listing is a 3D printed enclosure for the GBS-8200 video scalar board. It has been designed to hold a GBS-8200 and a BIT-C128 or GGLabs CGA2RGB converter. I recommend using 3M double-sided tape to secure the converter, if you use one.
The proprietary PLA filament used is color-matched to be as close as possible to a Commodore Amiga 500, but it would be right at home atop a Commodore 128 as well. Please keep in mind the age of these machines and the discoloration that can occur.
The enclosure uses heat-inserts to retain the fasteners. The design is such that the screws should sit flush with the bottom of the case. Over tightening is not recommended. Every enclosure was assembled and disassembled as part of the quality control process.
What you'll get:

Two enclosure halves (top and bottom)
Six (6) screws
One (1) Allen wrench
Four (4) silicone bumpers (for the bottom enclosure)
Four (4) black "tall button" caps
Four (4) yellow "short button" caps

You'll only need to use one set of the yellow or black button caps, depending on the version of the GBS board you have. Some GBS boards have tall buttons (4.5mm) and others have short buttons (3.5mm). The caps adjust for this difference.
Not CGA2RGB converter

BIT-C128 converter